Before going into hibernation in the early hours of 15 November 2014, the Philae lander was able to conduct experiments and return its data to Earth. In this blog post we look at the preliminary analysis conducted by the landersMulti-Purpose Sensors for Surface and Subsurface Science instrument package, MUPUS.

MUPUS began observing the environment around Comet 67P/Churyumov-Gerasimenko once Philae was released from the Rosetta orbiter at 08:35 GMT on 12 November (this is spacecraft time; the signal confirming separation arrived at Earth just over 28 minutes later, at 09:03 GMT).

The first touchdown recorded by Philae occurred at 15:34 GMT (with the signal arriving on Earth at 16:03 GMT), but it later transpired that the harpoons and ice screws did not deploy as planned and the lander subsequently rebounded, experiencing two further touchdowns, at 17:25 and 17:32 GMT (spacecraft time), respectively.

Because part of the MUPUS package was contained in the harpoons, some temperature and accelerometer data could not be gathered. However, the MUPUS thermal mapper, located on the body of the lander, worked throughout the descent and during all three touchdowns.

At Philaes final landing spot, the MUPUS probe recorded a temperature of 153C close to the floor of the landers balcony before it was deployed. Then, after deployment, the sensors near the tip cooled by about 10C over a period of roughly half an hour.

We think this is either due to radiative transfer of heat to the cold nearby wall seen in the CIVA images or because the probe had been pushed into a cold dust pile, says Jrg Knollenberg, instrument scientist for MUPUS at DLR.

The probe then started to hammer itself into the subsurface, but was unable to make more than a few millimetres of progress even at the highest power level of the hammer motor.

If we compare the data with laboratory measurements, we think that the probe encountered a hard surface with strength comparable to that of solid ice, says Tilman Spohn, principal investigator for MUPUS.

Looking at the results of the thermal mapper and the probe together, the team have made the preliminary assessment that the upper layers of the comets surface consist of dust of 1020 cm thickness, overlaying mechanically strong ice or ice and dust mixtures.

Read the original here:

Philae Settles in Dust-Covered Ice