In the specification of thermal insulation for piping, the design criteria is mentioned for wind speed is 0.5m/s for inside and 0.25 for ouside the plant build. is the wind speed is more inside the pland build?
Please also clarify the general design criteria for wind speed consideration for the
Dear experts,
We have a solid fire boiler of 5T capacity.Fuel used is Bricqute(Coffe+groundnuthusk+saw dust). We are getting heavy black smoke when running the boiler.
Need your advice pls.
Regards
L.Ramamurthy
It is required to carry out HAZOP study for water bath heater (Fuel Natural gas) - please furnish detaisl as how to proceed - Ypal
I want to know Which is the best Lubricant for HUB Greasing for HCV and LCV
Please provide details on the cause of Noise in Valves. Any suggestion on how to eliminate it. thanks
Hi Gents
If anybody having leea part 1 & 2 old question papers, Please send to id below:
hi friends
can you tell me in Building Management System logics (BMS)
that means AHU ,Chiller,VFD &etc...
for sequentional logic, PID logics ,& etc ...
i want know that creating new logic in any brands for EX Honeywell, Siemens,or any software .... for CARE , COMFORPOINT OR anyt
what is the specification of CEW Tubes & Seamless Tube
HOW CAN I BE IN A POSITION TO ACCESS ON OF THE BEST PROJECTS IN THE TRADE
I have been trying to find overhead conveyors to no avail.
PLease advise.
Antoine Semaan
What is the meaning of seamless pipe?
hi,everybody. i am a greener in designing some mechanical devices and get a serious problem. For example, i design a device for the client in US, the device must fit the American mechanical standard,and where could i find the documents online?
could anyone do me a favor to give me any address o
hello good morning,
y is it necessary to use mcc panel for chillers? is a simple control panel with isolator not sufficient 2 feed chiller? can a mcc panel feed chiller,ahu,fahu,circulating pumps al together? does mcc panel have 2 be installed in a room at roof where nearby chillers installed
I am a very experienced Rotating Equipment Engineer with nearly thirty years experience mainly in Refinery, Chemical and LNG plants. Would like to work in New Zealand for the next two to three years either as a contractor or on staff.
Would appreciate it if anyone had any good leads or reputabl
I am in the process of coming up with a method statement for installation of pre-fabricated flue stack parts. The challange is that this is a requirement that should accompany bid documents during tendering and no drawings have been supplied. I know the traditional approach of using a crane to inst
Regarding VFD, I came across a statement that,
"The problem that is created with the application is that a VFD will introduce a nominal 5% harmonic current into a motor in addition to the motor's normal running amperage. The harmonic current will generate 5% more heat within the motor than w
Hi, I need a linear actuator for a Continuously Variable Transmission (CVT). The CVT is intended primarily for automotive use but is applicable to anything or any size requiring a transmission. With the primary application being automotive, this makes for some quite wide ranging operating conditio
Which type of encoders used in offshore application?
how to define torque in two different parts like Alluminium & cast iron joint, metal to plastic joint.etc
Dear Fellow Engineers, Consultant and manufacturer, In the paralleling of multiple generator, two type of controls are being promoted by different Manufacturers: Item1. Generator synchronization control installed at the generator panel together with the built-in controls that monitors fuel, te