Video: How to Install a Nitrous Oxide Kit

In this episode, Chris Duke of Motorz TV shows you how to install a nitrous oxide kit on a 2008 Ford Mustang GT (S197). This wet kit from Nitrous Express includes everything you'll need under the hood, including the switches, bottle, bottle heater, and even a remote bottle opener. Chris also exp

LED Project Help

Been diggin around and it seems there are several here that seem to know thier stuff, so I have a LED Voltage/Current question.

I've built an RC Boat and I am using 5 LED yard lights as q-beams on it. The yard lights were originally powered by 3 AA Ni-Mh under a solar cell charge. During temp const

ROV Thruster Design Questions

Hello,

I am a high school student, and the team capitan of a high school robotics group. We are building an underwater robot to compete in the MATE International ROV Competition, against other high school and also college teams. For our robot, we want to construct some better thrusters than those w

What Capacitor to be Used?

I'm using a gear-motor with the following specs:

3-phase, 200v to 220v, 0.2Kw (200 watt), 28 rpm, 50-60 Hz, Amp 1.1 to 1.2, continuous, 4 poles.

What should be the U.F and volt of the capacitor to be used with this motor?

current capacitor is of 12UF and continuous but the number of volt is not p

DIY Battery Packs with Multiple Taps – Charging.

6 Sealed 6V-4.5AH Lead-Calcium Batteries in series (think exit sign cells).

36V charger used to charge the array.

Batteries are used to test devices at 12V, 18V, 24V & 36V .

1. Assume that the testing was just 12V and two of the batteries were used without rotation. Can these two batteries lo

Non-Invasive True BP Measurement?

Anyone aware of a non-invasive method of obtaining true BP? Traditional methods (arm cuff) assume the artery is perfectly elastic, and therefore any hardening of the artery will give BP higher than true. And most of us will have some hardening.

Anodizing AA380

My anodizer tried to black anodize some die-cast AA380 for me and it turned out light grey. Now he says it can't be done and I'll have to strip the grey, repolish the aluminum and do something else. Is he correct? Or is there a technique to rescue this piece and get a black anodized finish?

Idea For Graduation Project

Hi I'm aya I'm communication engineering student 4th year at Al-balqa applied university in Jordan

i want to help me in idea of graduation project combining (hardware and software) and tell me about courses i must take to have experience

CR4 Admin - email address removed

From the CR4 Rules: Do no

Flowmeter

Hi

I have an application in which flow needs to be measured on 2"line.Following are the conditions

1)The Flowmeter needs to installed on an MEG injection line to Subsea.So there is a chance of back flow(oil and gas) from subsea .So the flowmeter needs to measure the backflow of both oil and gas fr