HI,

How to fined a induction motor's insulation good or spoiled by testing

what is the proper and optimize solution if you want to control standalone skid for example (pumps and tanks) with very Little control points and more Little shutdown points?

Do we need separate control and safety system for this small system or we use one control system to do both process and

Does anyone on this forum provide me with some inforamtion on a 1000kjoules flywheel.

If there are any,at which price,and more phisical data.

On occasion when I start my 2010 Toyota it will run for about three seconds and then stall/shut-off. This problem will repeat itself six, seven times before finally starting. Also during this same time my ignition will stick once or twice and the motor continues to turn over until I actually turn th

Hello,

How to calculate transformer zero sequence impedance (Ohms per phase) for YNzn and ZNzn vector group? I have transformer design for 50 kVA, 1000/400 V, YNzn 11 vector group.

dear sirs,

can you please help me to find the standard that specified the number of films for each diameter of pipes and the length for film and type

regards

Do anybody have oximeter simulatio using simulink which the complete guide becasue i have tried the diagram one but could not do the tissue part...subsystem need to be define....

Why oil ring lubricated air compressor is not suitable for industrial instrument air service? What are the risks if oil contaminated air (greater than 0.001 PPM) is supplied to instruments of a mega chemical complex.

Dear All,

How transposition formed in transmission line , how to reduce it ?

----- The story began 9 months ago, when I bought a "pedelec", which is a bicycle with an electric assistance motor that enables one to ride the bicycle a longer distance, and faster as long as the battery [lead-acid] supplies power. I was told that the battery could be recharged 10

hi

im new engineer and i want to learn more about seals.

we had frequent seal failure on Hp Condensate Pump . after checking . we ffound that the failure of the seal due to vapor lock in the seal chamber and carbon deposits ( carbon solids will certainly damage the seal face) . we r using

anybody guide me where can i buy asbestos cloth strip roll ( wide 100 mm,thickness 6mm min) at dubai.

i need emergency for my plant.]

i am awaiting any reply from my cr4 membership friends.

Dear Sir,

we are having a PSA nitrogen plant with 110CFM capacity with a duty cycle of 80%. We are currently leavin the exhaust gases to atmosphere. we are planning to know, if these oxygen rich exhaust gases can be recovered.
Has any research been done on this, or any plant in your

Hi everyone,

Can anyone help me to guide correct procedure for home PC or laptop security against spyware and viruses????????

Please suggest me reliable antiviruses softwares.

Hi all, are there any differences between the plates of the normal plate heat exchangers and the 'dimple plate' of the dimple plate heat exchangers?

Thanks!

Hello

I am seeing this 2MHz impulse noise in mains power line coming out of some kind of pick-up signal from RF in air. it has five or seven cross overs and starts rising to peak at mid point and then decays in same manner making it symmetrical on both sides with resonance like trace. It comes ou

what is the test procedure to check the whitness of the gypsum ?

You can see what I mean starting from 7 minutes 20 seconds into the video

I have tried something with one dish a couple of years ago but the change of center of gravity caused it to be too hard to turn the equatorial mount. But with this, one

What are the appropriate steps used to get the correct settings for the controller of a load tap changer? How is the reactance and resistance settings found?

I am trying to syphon water through 600ft of 1 1/4" poly pipe.

The intake is above exit by around 22 ft and the line goes up and down a few times.

I cannot get it to work even after priming it with a pump.

Any sugestions