frnds,we knw tat there is three terminals for ceiling fan.

they r starting coil terminal,running coil terminal,neutral.

but how can we find which is which?

we have a unbalance motor for vibrating screen of 8.76 kw,recently we replaced its oth side bearing with new one (one side spherical bearing and another side cylindrical NU bearing) after assembling we observe some rubbing sound from NU side bearing,after checking we found we replaces NU2320C4 beari

Everyone nowadays is yelling"Accident " to cover for some terrible bad publicity.

Google claims it accidentally collected data from WiFi ports, and as a remedy , it will no longer monitor for WiFi hot spots.

They claim they would have never known about it except for a German request fo

WHAT IS THE PROCESS OF commissioning A PIPELINE SECTION

I am trying to work with alignments; and when I edit a profile, this means the elevations are changed to what I want the road level to be.. How do I label these new elevations on the alignment centreline automatically thru the software.

If there is an aluminium cylinder whose length is 2000mm and its internal dia is 300mm and external 600mm and the temperature rise of cylinder is 30C(degree centigrade). how can we find its increase in length and dia ???????

hay every boudy

Im looking for how can i design the culvert renforcement concrete ?

SABAH RAHI

I have an old gas powered DC welder, could I use it for a wind turbine to power my shop? Could I also couple a hydraulic pump to the turbine blades and run hydraulic lines down to a hydraulic motor which would then be coupled to the DC welder to produce power?

Niko

The U.S. medical device industry can expect increasing scrutiny in the near term as the FDA revises pre-market notification and product safety requirements. Device makers should prepare pro-actively to ensure that they can continue to compete and innovate as regulations evolve. The electronic medica

best way to butt weld 18 gauge 430 stainless

Do you have any working experience on 3200A Schneider Masterpact NW(NW32-H1) series breaker (to be used for Load center cum MCC)?

http://www.sciencedaily.com/releases/2010/05/100513064215.htm

just come across this and thought i would share it

SA 516 GR 70 SUITABLE FOR PIG TRAP

Dear Friends,

I am willing to do M.Phil in Management through Distance Education system, Could anyone please provide me the info in which universities of India such course is available.

I have recently completed my MBA-Finance from Sikkim Manipal University.

Rgds.

Please, I've an need for the forums consensus on the following:

1: Would anybody care to comment on the industry accepted reccommended practice for the deployment of Floating versus Trunnion Mounted Ball valves on pipelines for pigging service? Which is prefered (floating ball or trunnion m

I am a fresh electrical design engineer for desiging of control panels.i have some confusion that where i have to use ON delay timer & OFF delay timer in the control circuit

if any one guide me i am very thankfull.

dear sir ,

i have a generator and ATS , could you give me the standard time for starting , loading and cooling down .

regard

Dear sir,

What could be the 220kV Bus bar materials for a power station rated at 3150 Amperes?

Regards,

sks

1. While I reply to a quiery in CR 4, I want to attach a graph and some other data and attach a photo so that it can be fully understood. I am not able to do this and How to ATTACH DATA OR PASTE DATA, I would prefer PASTING DATA.

2. Many Participants of CR4 members, they mention "LOOK HERE

How to find out the solar factor that can be used for heat load estimation from the proposed glazing tech specs(U Value, SC & SHGC)?